2008 ADL 2000M X

 NOTE: 0n 2008 ADL Models you must remove the Thermocouple wire when replacing this board. It is not needed with the new board.(See below)

 

 

Touch Key Pad with Cover Please Note: This is a retro fit and no longer has a IR sensor for your remote control. You must add the Remote sensor below if you want to continue using a remote control.

 

 

Remote Sensor Please note: This is only needed if you are using the remote control. This is a retro fit and must be added behind the flame screen.

 

 

 

 

 

Thermocouple Wire - Remove with New Control Board

 

 

 

 

Note: You may have to cut and splice the wires from the new motor to the existing connections the the main control board. You may also have to make a new hole in the rubber connector on the flame rod to line up with the hole to the new Syncro motor. Length and wire connections may very from picture shown.