Y10
Â
From the list below, select the part that is being replaced. It will then give you a list of all the parts including the bad part that needs to be replaced with it. If just the bad part shows up, then no additional parts are needed with it.
Â
Â
  Main Control Board  The Main Control board has been replaced with the W10 Main Control board and 6 other parts will be needed when changing this board out. Please click on the picture to see all the parts necessary.
PLEASE NOTE: the unit will not work without replacing/adding all the necessary parts on the list. The tip switch will have to be added by drilling 2 mounting holes to the side of the cabinet on the inside. This is a big job and is recomended to be done only be done by an expert.
Â
Y ConnectorÂ
Used When unable to solder the control board. OEM has the load and neutral line-in connections soldered to the reset button and to the main control board at ANC3. To replace Main Control Board a 14AWG Y-connector must be used on ANC2. Replacement cord and reset switch (below) may also be required if you are not able to securely attach spade connectors to old cord.
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â
Â